MATERIALS & PERFORMANCE

How Film Selection Affects Helium Balloon Float Time

1. Our PA/PE composite film construction

For the nylon-film construction described here, the nominal laminate comprises a 0.012 mm PA (nylon) layer and a 0.016 mm PE layer, totaling 0.028 mm before the additional coatings and print finish. The PA film is metallized, and the design is printed on the metallized surface. Depending on the coating and printing specification, the finished thickness is approximately 0.029–0.030 mm. Unprinted silver balloons may be slightly thinner. These figures describe this construction, rather than every foil balloon on the market.

SPECIFIED PA/PE CONSTRUCTION

LayerNominal thickness
PA / nylon0.012 mm
PE0.016 mm
Base laminate0.028 mm
Finished, with coatings and printApprox. 0.029–0.030 mm

2. Film thickness, barrier performance and floating time

Helium can gradually permeate through a polymer film even when the balloon is properly sealed. This involves gas dissolving in and diffusing through the material; it is not simply leakage through fixed holes between molecules. For an otherwise comparable film, increasing thickness can reduce gas transmission. However, thickness alone does not determine performance: polymer composition, metallization quality, coating continuity, defects and the complete laminate structure also matter.

Our specified nylon-film option for these helium balloon projects uses a nominal 0.028 mm PA/PE laminate. Alternatives may use PET-based laminates or nominal thicknesses such as 0.026 mm or 0.024 mm. Compare the actual specification and test results rather than judging helium retention by material name or thickness alone. A 0.028 mm nylon laminate is our stated option here, not a universal maximum thickness for helium balloons.

Metallization can contribute substantially to gas-barrier performance. Printing may also affect the overall construction, but its contribution should not be assumed without testing. A thicker film also increases balloon weight, so longer gas retention does not automatically mean longer floating time. Balloon size and shape, helium purity, inflation level, valve and seal quality, accessories and environmental conditions affect the result.

3. Quality control and distinguishing leaks from permeation

Our quality inspectors carry out in-process checks and sample inflation tests at heat sealing, die cutting, packing and finished-goods stages. Gas leakage is treated as a critical quality issue and is addressed through our established inspection process.

If the balloon edge has not been sealed, helium escapes through the open edge and the balloon deflates within a few minutes. This is different from a comparison in which properly sealed balloons remain afloat for six or seven days. Gradual helium permeation through the film is a separate process from leakage through an unsealed edge.

4. Pre-production helium testing and customer approval

Before a new helium balloon design enters production, we make pre-production samples and conduct quality checks, including a helium observation log. We record the inflation time, visible appearance changes at 24-hour intervals and the time at which the balloon stops floating.

Wrinkling is assessed visually and recorded descriptively. This observation method is subjective: it does not precisely measure the amount of helium remaining or the helium transmission rate through the film. The time a balloon stops floating and its appearance are separate observations and should both be recorded.

Different sizes and shapes can behave differently. For meaningful comparisons, keep helium purity, inflation method, room conditions, attached weights or ribbons and observation intervals consistent, and identify each sample. Pre-production samples are also sent to the customer for testing and approval before bulk production begins.

Discuss your film specification and sample test requirements →